OEM Carrier Ignition Control Board LH33WP007 for Model PY4GPAB42060NA

This is the factory OEM ignition control board (IGC board) for the Carrier PY4GPAB42060NA packaged HVAC unit, carrying Carrier part number LH33WP007. The ignition control board is the command center of your system's heating sequence — it manages the inducer motor, hot surface igniter, gas valve, and flame sensor in precise, timed sequence. When this board fails, symptoms typically include a no-heat lockout, the system cycling on and off without igniting, error codes on the thermostat, or a complete failure to initiate the heating cycle.

• Specs: 24V control voltage | 60 Hz | OEM part number LH33WP007 | Cross-references: 1068-15, 1068-83-119A, 1836V03 | Ship weight approx. 0.84 lbs
• OEM vs Generic: This is a genuine Carrier factory board with exact firmware, relay ratings, and terminal configuration pre-matched to the PY4GPAB42060NA. Aftermarket boards risk timing mismatches that can trigger nuisance lockouts or void equipment warranties.
• Install Difficulty: 3/5 — Disconnect power at the disconnect box before servicing. Tools needed: 1/4" nut driver, flathead screwdriver, needle-nose pliers, phone/camera to photograph wiring before removal. Label every connector before pulling the old board. A multimeter is strongly recommended to verify 24V control voltage before replacement.
• Warranty: 1-year OEM factory warranty. In-stock and ships same business day from our warehouse.

Compatibility: Engineered as a direct OEM replacement for the Carrier PY4GPAB42060NA packaged unit. Always cross-reference your existing board's part number and any sticker revisions before ordering. Not sure it fits? Our HVAC parts specialists will verify fitment at no charge — contact us before you order.