OEM Carrier Flame Sensor 48GS400192 for Model PY3PNA036060NA

This is the genuine OEM Carrier flame sensor (part number 48GS400192), factory-specified for the Carrier PY3PNA036060NA gas furnace. The flame sensor is a safety-critical component — its flame rod extends into the burner assembly and uses ionization/rectification to confirm an active flame during each heating cycle. When it fails or becomes coated with oxidation, the control board receives no flame-confirmation signal and shuts down gas flow within 5–8 seconds of ignition as a safety lockout, leaving your home without heat.

• Specs: 90° angled flame rod with integrated mounting bracket | Factory-matched rod length ~1.6" | Overall assembly approx. 4.9" × 1.75" | OEM part number 48GS400192
• OEM vs Generic: This genuine Carrier OEM sensor is manufactured to exact factory tolerances for consistent microamp signal output. Generic alternatives may produce weaker or inconsistent ionization signals, causing nuisance lockouts or premature control board wear.
• Install difficulty: 2/5 — Shut off power and gas before beginning. Tools needed: 1/4" or 5/16" nut driver, lightly abrasive pad (for rod cleaning during inspection), multimeter (to verify microamp draw post-install). Disconnect the single wire connector, remove the mounting screw, and swap the sensor — typical job under 15 minutes.
• Warranty: 1-year OEM manufacturer warranty against defects. Ships same business day from our warehouse.

Compatibility: Engineered specifically for the Carrier PY3PNA036060NA gas furnace. Verify your existing part number on the sensor body or equipment data plate before ordering. Not sure it fits? Our HVAC parts team will confirm fitment before you buy — order with confidence and get back to heat fast.