OEM Carrier 2-Pole Contactor 30 Amp 24V Coil for Model PY2PPB060115NB (HN52KC025)

This OEM-matched 2-pole contactor is the factory-specified replacement for the Carrier PY2PPB060115NB packaged unit. The contactor acts as the high-voltage relay that energizes the compressor and condenser fan circuit in response to a 24V signal from the thermostat or control board. When this component fails — due to worn contacts, a burned coil, or pitted terminals — the system will typically hum but fail to start, short-cycle immediately on a call for cooling, or simply not respond at all to a thermostat demand.

• Specs: 2-Pole | 30 Amp (FLA 20 / RES 30) | 24V AC Coil | 50/60 Hz | Replaces OEM Part# HN52KC025 (current OEM successor: HN52KC024)
• OEM vs Generic: OEM-grade contactors are built to exact Carrier factory tolerances with silver-alloy contact points, ensuring full rated ampacity and extended contact life. Generic contactors often use lower-grade alloys that pit and weld faster under high cycling loads.
• Install Difficulty: 2/5 — Shut off all power at the disconnect and breaker before beginning. Tools needed: flathead and Phillips screwdrivers, needle-nose pliers, wire labels or tape for terminal identification. Always photograph existing wiring before disconnecting any leads. Swap one wire at a time to avoid miswiring.
• Warranty: 1-year OEM-grade warranty. In-stock and ships same business day from our warehouse.

Compatibility: Designed for Carrier model PY2PPB060115NB packaged gas/electric units. This 2-pole 30A 24V contactor also cross-references with many Carrier, Bryant, and Payne systems — always verify pole count, amp rating, and coil voltage against your unit's data plate before ordering. Our team is available to confirm fitment prior to purchase.