OEM Carrier Condenser Fan Motor 1/4 HP 208-230V 1100 RPM for Model PY1PPB042090AAAA

This factory-authorized OEM condenser fan motor (part #HC39GR234) is the direct replacement for the Carrier PY1PPB042090AAAA split-system heat pump. The condenser fan motor drives the outdoor fan blade, pulling air across the condenser coil to reject heat during cooling mode and absorb heat during heating mode. When this motor fails, you'll typically notice the outdoor fan not spinning, the system short-cycling on high-pressure lockout, or the compressor overheating and tripping its thermal overload — all of which result in complete loss of cooling or heating capacity.

• Specs: 1/4 HP | 208-230V | 1-Phase | 1100 RPM | 1.50 Amps | 60 Hz | Counterclockwise rotation (shaft up) | 1/2" shaft diameter | 1.5" shaft length | Frame 48 | 5 5/8" diameter housing
• OEM vs Generic: This is a genuine Carrier Factory Authorized Part (HC39GR234) built to exact OEM tolerances for voltage, RPM, and rotation direction. Generic aftermarket motors often deviate in rotation, shaft length, or amp draw — causing fan blade clearance issues, capacitor mismatches, and premature motor burnout.
• Install Difficulty: 3/5 — Disconnect power and lock out the breaker before beginning. Tools needed: 5/16" and 3/8" nut drivers, flathead screwdriver, multimeter, and wire crimps. Photograph all wiring and rotation direction before removal. Important: Always replace the run capacitor at the same time — a capacitor out of tolerance is a leading cause of new motor failure.
• Warranty: 1-year OEM factory warranty against defects. In-stock orders ship same business day from our warehouse.

Compatibility: Engineered specifically for the Carrier PY1PPB042090AAAA heat pump condenser unit. Cross-references include HC39GR234A and GE/Genteq model 5KCP39GGY910S. Verify your unit's data plate voltage and HP rating before ordering. Our HVAC parts specialists are available to confirm fitment — contact us before you buy for peace of mind.