OEM Carrier Flame Sensor Assembly LH33WZ005 for Model PY1PPA060100AEBA

This OEM Carrier flame sensor assembly (part# LH33WZ005) is the factory-specified replacement for the Carrier PY1PPA060100AEBA packaged heating and cooling unit. The flame sensor is a critical safety and operational component — its flame rod extends into the burner assembly and passes a small current through the burner flame to confirm ignition. If the control board does not receive that confirmation signal within seconds, it shuts off the gas valve as a safety measure. A contaminated or failed flame sensor is one of the most common causes of a furnace that lights, runs briefly for 5–8 seconds, then locks out on a fault code.

• Specs: OEM Carrier flame sensor assembly | 64.5" integrated wire harness | Factory-matched flame rod material and geometry | OEM part# LH33WZ005 | Factory Authorized Parts (FAP) designation
• OEM vs Generic: This is a genuine Carrier Factory Authorized Part. OEM sensors use exact rod alloy and bracket geometry for reliable microamp signal output. Generic sensors can produce inconsistent microamp readings, causing nuisance shutdowns or failing to protect against true ignition failure.
• Install difficulty: 2/5 — Shut off gas and 24V power before servicing. Tools needed: 1/4" nut driver, flat-head screwdriver, multimeter (microamp mode to verify signal). Disconnect existing harness connector, remove mounting screw, swap sensor, reconnect harness, and verify flame signal reads 1–10 µA DC on first fire.
• Warranty: 1-year OEM factory warranty. Ships same business day from our warehouse when ordered before cutoff.

Compatibility: Engineered specifically for the Carrier PY1PPA060100AEBA packaged unit. Always cross-reference your unit's data plate and wiring diagram to confirm part number before installation. Our fitment team is available to verify compatibility before you order — contact us with your full model and serial number.