OEM Carrier Flame Sensor Assembly LH33WZ005 for Model PY1PEA060100AEBA

This is the genuine OEM Carrier flame sensor assembly (part number LH33WZ005), the factory-specified replacement for the Carrier PY1PEA060100AEBA packaged unit. The flame sensor — also called a flame rod — monitors the burner flame via the principle of flame rectification, sending a small microamp signal to the control board to confirm combustion is present. When the sensor fails or its rod becomes coated with oxidation, the control board cannot verify the flame and shuts off the gas valve as a safety measure, typically 5 to 8 seconds after ignition. The result: the system lights briefly, then shuts down and locks out — a telltale sign of a dirty or failed flame sensor.

• Specs: OEM Carrier Factory Authorized Part | 64½" wire lead assembly | Flame rod (rectification-type sensor) | Direct OEM replacement, no modification required
• OEM vs Generic: This is a genuine Carrier Factory Authorized Part engineered to exact rod geometry and metallurgy tolerances. Generic flame sensors may have incorrect rod angles or inferior alloy coatings, leading to weak microamp signals, nuisance lockouts, and premature failure.
• Install difficulty: 2/5 — Shut off power and gas before servicing. Tools needed: 1/4" hex driver or nut driver, needle-nose pliers. Disconnect the wire lead connector, remove the single mounting screw, swap the rod assembly, and reconnect. Always verify microamp signal (1.5–4 µA typical) with a multimeter after replacement.
• Warranty: 1-year OEM factory warranty. In-stock and ships same business day from our warehouse.

Compatibility: Direct OEM replacement for the Carrier PY1PEA060100AEBA packaged unit. Verify your existing part number on the sensor body or equipment wiring diagram before ordering. Our fitment specialists are available to confirm compatibility before you buy — no guesswork required.