OEM Carrier Condenser Fan Motor 1/10 HP 208-230V for Model PH4ANG018000BAAA

This is the genuine OEM factory-specified condenser fan motor for the Carrier PH4ANG018000BAAA heat pump condensing unit. The condenser fan motor drives the fan blade that pulls air across the outdoor coil, dissipating heat from the refrigerant. When this motor fails, the condenser fan stops spinning — causing the system to overheat, trip the high-pressure limit, and shut down entirely. Common failure symptoms include a buzzing outdoor unit with no fan movement, intermittent short-cycling, or the compressor shutting off on high-pressure lockout after a few minutes of operation.

• Specs: 1/10 HP | 208–230V | 60 Hz | 0.75 Amps | 1100 RPM | Single Speed | Single Phase | Closed Enclosure | CW Rotation (shaft up) | 1.5" Shaft Diameter | 48 Frame
• OEM vs Generic: This is a factory-matched OEM motor built to exact Carrier tolerances for airflow, amperage draw, and thermal protection. Generic aftermarket motors frequently run at off-spec RPM or amperage, shortening compressor life and voiding equipment warranties.
• Install Difficulty: 3/5 — Disconnect power at the breaker and verify zero voltage before beginning. Tools required: multimeter, 5/16" and 3/8" nut drivers, wire stripper, and needle-nose pliers. Photograph all wiring before disconnecting leads. Torque the blade set-screw to spec and confirm blade pitch and rotation direction before powering up.
• Warranty: 1-year OEM manufacturer warranty. Ships same business day from our climate-controlled warehouse.

Compatibility: Engineered as a direct OEM replacement for Carrier model PH4ANG018000BAAA. Also fits Bryant and Payne units sharing the HC34GE239 specification. Always verify HP, voltage, RPM, rotation, and shaft diameter against your unit's data plate before ordering. Our HVAC parts specialists are available to confirm fitment — order today and receive same-day shipping on in-stock units.