OEM Carrier Condenser Fan Motor 1/8 HP 825 RPM for Model PH2PPB030000AB

This is the genuine OEM factory-specified condenser fan motor (part number HC35GE235) for the Carrier PH2PPB030000AB heat pump condensing unit. The condenser fan motor drives the outdoor fan blade, pulling air across the coil to reject heat during the cooling cycle and absorb heat during heating. When this motor fails, the outdoor fan stops spinning, causing the compressor to overheat, trip the high-pressure limit, and shut the system down — often within minutes of startup. Common symptoms include the outdoor unit running briefly then shutting off, a hot cabinet, or a humming motor that won't turn over.

• Specs: 1/8 HP | 825 RPM | 208–230 VAC | 60 Hz | Single Phase | 0.90 Full Load Amps | PSC (Permanent Split Capacitor) motor type | Clockwise rotation | Continuous duty
• OEM vs Generic: This is a genuine Carrier OEM part (also cross-referenced as Genteq/GE model 5KCP39FFS244CS). OEM motors are wound and balanced to exact factory tolerances, ensuring correct airflow, amp draw, and service life. Generic alternatives often vary in rotation direction, shaft diameter, or RPM — all of which can damage the fan blade or cause premature failure.
• Install difficulty: 3/5 — Requires disconnecting power and discharging any run capacitor before removal. Tools needed: nut driver set, wire stripper, multimeter, and a wiring diagram (included with OEM part). Always replace the run capacitor when replacing the motor — a weak capacitor is the most common cause of motor burnout.
• Warranty: 1-year OEM factory warranty against defects in materials and workmanship. Ships same business day from our warehouse when ordered before cutoff.

Compatibility: Directly fits Carrier model PH2PPB030000AB. Also cross-references to HC35GE235A and GE Genteq 5KCP39FFS244CS. Always verify HP, RPM, voltage, and rotation direction against your unit's data plate before ordering. Our technical team is available to confirm fitment — reach out before you buy for peace of mind.