OEM Carrier Condenser Fan Motor 1/4 HP 208-230V 1100 RPM for Model PH1RPA036000AAWA

This OEM Carrier condenser fan motor (part number HC39GR234) is the factory-specified replacement for the Carrier PH1RPA036000AAWA split-system heat pump. The condenser fan motor drives the outdoor fan blade, pulling air across the condenser coil to reject heat during cooling mode and absorb heat during heating mode. When this motor fails, you'll typically see the outdoor fan stopped or spinning sluggishly, the compressor overheating and tripping on high-pressure lockout, or the system shutting down entirely to protect itself from thermal damage.

• Specs: 1/4 HP | 208-230V | 1-Phase | 1100 RPM | 1.5 Amps | 60 Hz | CWLE rotation | Frame 48/39 | 0.5" shaft diameter | 1.5" shaft length | Vertical mount only
• OEM vs Generic: This is a genuine Carrier factory-authorized GE/Genteq motor built to exact OEM tolerances. Generic aftermarket motors frequently deviate in RPM, rotation direction, and shaft dimensions — causing fan blade wobble, vibration-induced bearing failure, and voided equipment warranties.
• Install difficulty: 3/5 — Disconnect power and discharge the run capacitor before beginning. Tools needed: 1/4" and 5/16" nut drivers, wire stripper, multimeter, and a fan blade puller. Always photograph wiring before disconnecting leads. Note: It is strongly recommended to replace the run capacitor simultaneously — a weak or failed capacitor is a leading cause of premature motor burnout.
• Warranty: 1-year OEM factory warranty against defects. Ships same business day from our warehouse.

Compatibility: Designed for the Carrier PH1RPA036000AAWA heat pump condenser. Cross-references GE/Genteq model 5KCP39GGY910S. Verify horsepower, voltage, RPM, rotation, and shaft dimensions against your unit's data plate before ordering. Our fitment team is available to confirm compatibility before you buy — no guesswork required.