OEM Carrier Condenser Fan Motor 1/4 HP 208-230V 1100 RPM for Model PH1RJA036000AAWB

This is the genuine OEM factory-specified condenser fan motor for the Carrier PH1RJA036000AAWB split-system heat pump. The condenser fan motor drives the outdoor fan blade, pulling air across the condenser coil to reject heat and keep the refrigerant circuit operating within design pressures. When this motor fails, your system will run but the outdoor fan will stop spinning — leading to rapid high-pressure lockout, compressor overheating, and a complete no-cool or no-heat condition. In some cases the motor hums but does not spin, or trips the outdoor unit's breaker.

• Specs: 1/4 HP | 208-230V | 1-Phase | 1100 RPM | 1.5 Amps | 60 Hz | Frame 48 | CWLE rotation (counterclockwise looking at lead end) | 1/2" shaft diameter | 1.5" shaft length | Vertical mount only
• OEM vs Generic: This is a genuine Carrier factory part — not an aftermarket clone. OEM motors are wound to exact torque, thermal protection, and balance specs for the PH1RJA036000AAWB. Generic motors may differ in shaft length, rotation direction, or thermal cutout rating, risking premature failure or compressor damage.
• Install Difficulty: 3/5 — Disconnect and lock out power before starting. Tools needed: 1/4" and 5/16" nut drivers, wire stripper, needle-nose pliers, multimeter. Photograph all wiring before disconnecting. Confirm fan blade rotation direction (CWLE) before securing. Pro tip: Always replace the run capacitor at the same time — a weak capacitor is the #1 cause of new motor failure.
• Warranty: 1-year OEM factory warranty. In stock and ships same business day from our warehouse.

Compatibility: Factory-matched replacement for Carrier model PH1RJA036000AAWB. Always verify voltage, horsepower, RPM, rotation direction, shaft diameter, and mounting orientation against your unit's data plate before ordering. Our HVAC parts specialists are available to confirm fitment — contact us before you buy if you have any questions.