OEM Carrier Condenser Fan Motor 1/4 HP 208-230V — HC39GR234 for Model PH1PNB048000AAAA

This OEM condenser fan motor is the factory-specified replacement for the Carrier PH1PNB048000AAAA packaged unit. The condenser fan motor drives the outdoor fan blade, pulling air across the condenser coil to reject heat and maintain proper refrigerant pressures. When it fails, the condenser section overheats, triggering high-pressure lockout or causing the compressor to short-cycle — often leaving the system blowing warm air or shutting down entirely within minutes of startup.

• Specs: 1/4 HP | 208-230V | 1-Phase | 1100 RPM | 1.5 Amps | 60 Hz | Frame 48Y (5-5/8" diameter) | 1/2" shaft diameter | 1.5" shaft length | CWLE rotation | Vertical mount only
• OEM vs Generic: This OEM motor is wound and balanced to factory tolerances, ensuring correct airflow CFM and thermal protection activation points. Generic motors often deviate in RPM and amperage draw, accelerating compressor wear and voiding equipment warranties.
• Install difficulty: 3/5 — Disconnect power at the breaker and verify zero voltage before opening the unit. Tools needed: 1/4" and 5/16" nut drivers, wire stripper, multimeter, and a fan blade puller. Always photograph all wiring connections and verify rotation direction before buttoning up the panel. It is strongly recommended to replace the run capacitor at the same time — a degraded capacitor is a leading cause of premature motor failure.
• Warranty: 1-year OEM manufacturer warranty. In-stock and ships same business day from our warehouse.

Compatibility: Designed for the Carrier PH1PNB048000AAAA packaged unit (4-ton, 208-230V). OEM part number HC39GR234 has been superseded by HC39GE238 — both are fully interchangeable. Verify voltage, HP, and RPM on your unit's data plate before ordering. Have questions about fitment? Our HVAC parts specialists verify compatibility before you buy — reach out today and get your system back up fast.