OEM Carrier Single-Pole Contactor 30A 24V Coil for Model PH16NA02400GBAAA

This is the factory OEM replacement contactor for the Carrier PH16NA02400GBAAA heat pump system. The contactor is the high-voltage relay that receives a 24V signal from the thermostat and closes the circuit to energize the compressor. When it fails — whether from pitted or burned contacts, a stuck open coil, or welded contacts — your outdoor unit will either refuse to start, run continuously without cycling off, or trip the breaker entirely. Replacing the contactor is one of the most common and cost-effective HVAC repairs a homeowner or technician can perform.

• Specs: 1-Pole configuration | 30A Full Load Amps (FLA) | 150A Locked Rotor Amps (LRA) | 24V AC coil voltage | 50/60 Hz | OEM Part# HN51KC024
• OEM vs Generic: This is a genuine Carrier Factory Authorized Part, engineered to exact factory specifications for the PH16NA02400GBAAA. Generic contactors may deviate in contact gap, coil pull-in voltage, and contact plating — leading to premature failure or nuisance trips.
• Install difficulty: 2/5 — Shut off power at both the disconnect and breaker before beginning. Tools needed: flathead and Phillips screwdrivers, needle-nose pliers, a multimeter for coil continuity check. Always photograph all wiring before disconnecting terminals.
• Warranty: 1-year OEM factory warranty. In-stock and ships same business day from our warehouse.

Compatibility: Fits Carrier model PH16NA02400GBAAA. This single-pole contactor is also commonly used across Carrier, Bryant, and Payne residential and light-commercial air conditioning and heat pump systems up to 5 tons (60,000 BTU). Verify your existing contactor's pole count, amperage, and coil voltage against your unit's data plate before ordering. Have a fitment question? Our team confirms compatibility before you buy — just reach out.