OEM Carrier Transformer 60VA 115/208/230V for Model PH13NA024000ABAA

This is the factory OEM replacement transformer for the Carrier PH13NA024000ABAA heat pump system. The transformer steps down high-voltage power (115/208/230VAC primary) to the 24V control circuit voltage that powers your thermostat, contactor coil, and control board. When the transformer fails, the entire low-voltage control circuit goes dead — the thermostat goes blank, the system stops responding to calls for cooling or heating, and in some cases a burnt smell or a tripped fuse on the control board will confirm the fault.

• Specs: 60 VA rating | Primary voltage: 115/208/230 VAC | Secondary voltage: 24V | Foot-mounted design | OEM Part Number: HT01AW229 | Cross-references: HT01AW229A, CIN-TRAN, 30-BV2006, 30-1814A
• OEM vs Generic: This is a genuine Carrier Factory Authorized Part built to exact VA and voltage tolerances. Generic transformers often run near the edge of their VA rating, causing premature thermal cutout trips and shortened service life — especially in high-demand heat pump applications.
• Install difficulty: 3/5 — Shut off all power at the disconnect and breaker before beginning. Tools needed: flathead and Phillips screwdrivers, wire stripper, needle-nose pliers, multimeter. Label and photograph all low-voltage wiring connections before removal. Verify primary tap selection matches your supply voltage.
• Warranty: 1-year OEM factory warranty. Ships same business day from our warehouse when ordered before 3 PM local time.

Compatibility: Designed as the direct OEM replacement for the Carrier PH13NA024000ABAA heat pump. Always verify your unit's data plate voltage and VA requirements before ordering. Our technical team is available to confirm fitment — just reach out before you buy.