OEM Carrier Condenser Fan Motor 1/4 HP 208-230V 1100 RPM — PH10PA04800GACAA (HC39GE237 / HC40GE232)

This is a genuine OEM Carrier condenser fan motor, factory-specified for the Carrier PH10PA04800GACAA packaged heat pump unit. The condenser fan motor drives the outdoor fan blade to pull air across the condenser coil, releasing absorbed heat into the outside environment. When this motor fails, the system will overheat, trip its high-pressure limit, and shut down — often within minutes of starting. You may notice a humming sound with no fan blade movement, or the fan spinning intermittently before the unit locks out on a fault code.

• Specs: 1/4 HP | 1100 RPM | 208-230V Single Phase | Frame 48Y (5-5/8" diameter) | 1.5" shaft extension | CW rotation (lead end) | 3-wire | OEM part numbers: HC39GE237, HC40GE232
• OEM vs Generic: This factory-authorized OEM motor is wound to exact Carrier tolerances for voltage, RPM, and amperage draw. Generic aftermarket motors can run off-speed or at higher amp draw, shortening compressor life and voiding equipment warranties.
• Install difficulty: 3/5 — Requires disconnecting power at the breaker and capacitor discharge before starting. Tools needed: 1/4" and 5/16" nut drivers, wire stripper, needle-nose pliers, multimeter, and a fan blade puller (strongly recommended to avoid blade or shaft damage). Photograph all wiring connections before disconnecting. Match rotation direction and shaft length before mounting.
• Warranty: 1-year OEM factory warranty. In-stock and ships same business day from our warehouse.

Compatibility: Direct OEM replacement for Carrier model PH10PA04800GACAA packaged heat pump units. Also cross-references HC39GE237A, HC39GE236A, HC39GE234A, HC39GE232A, HC37GE232, HC39GE231, and GE Genteq 5KCP39FGS071S. Always verify HP, voltage, RPM, frame size, and rotation on your unit's data plate before ordering. Our fitment team is available to confirm compatibility before you buy.