OEM Carrier Hot Surface Igniter LH33ZG001 for Model PG9MAB060080ABSA

This is the factory OEM hot surface igniter (part number LH33ZG001) for the Carrier PG9MAB060080ABSA gas packaged unit. The igniter is the first component to activate during every heating cycle — it heats to over 2,000°F to ignite the gas burner reliably and safely. When it fails, the furnace will attempt ignition, fail to light, and enter safety lockout, leaving you with no heat. Common symptoms include the inducer running normally but the burner never firing, or a fault code indicating failed ignition after 1–3 attempts.

• Specs: 120V hot surface igniter | Silicon nitride element | Factory-matched OEM geometry and lead length | Part number LH33ZG001
• OEM vs Generic: This is a genuine Carrier OEM part, manufactured to exact factory tolerances. Generic igniters vary in element composition and connector fit, which can cause premature cracking, intermittent ignition failures, and shortened service life — especially in packaged rooftop units exposed to thermal cycling.
• Install difficulty: 2/5 — Always de-energize the unit at the disconnect before beginning. Never touch the igniter element with bare hands — skin oils cause hot spots that crack the element. Tools needed: ¼" nut driver, needle-nose pliers. Photograph wiring harness before disconnecting. Slide the igniter bracket free, swap the element, reconnect the plug, and verify ignition on the next call for heat.
• Warranty: 1-year OEM manufacturer warranty. In stock and ships same business day from our warehouse.

Compatibility: Direct OEM replacement for Carrier model PG9MAB060080ABSA gas packaged units specifying part number LH33ZG001. Verify your unit's parts list or data plate before ordering. Have questions about fitment? Our HVAC parts specialists verify compatibility before you buy — order with confidence.