OEM Carrier Flame Sensor LH680013 for Model PG9MAB060080AASA

This is the OEM factory-replacement flame sensor for the Carrier PG9MAB060080AASA gas furnace. The flame sensor — also called a flame rod — is a safety component that detects the presence of a burner flame by passing a small electrical current through the ionized gas. If the control board doesn't receive that signal within seconds of ignition, it will cut gas flow and lock out the furnace. A dirty or failed sensor is one of the most common causes of a furnace that lights briefly and then shuts off after 5–8 seconds, often triggering a lockout fault code.

• Specs: OEM Part Number LH680013 | Rod-type flame sensor | Factory-matched signal threshold | Direct plug-in connector for PG9MAB060080AASA
• OEM vs Generic: The OEM LH680013 sensor is manufactured to Carrier's exact microamp sensing tolerances. Generic alternatives frequently drift out of spec, causing nuisance lockouts or premature failure — especially on tightly calibrated IFC boards.
• Install Difficulty: 2/5 — Shut off gas and power before servicing. Tools needed: 1/4" hex driver or nut driver, fine steel wool or emery cloth (for rod cleaning verification), and a multimeter to confirm microamp draw post-install. The sensor is typically accessible once the burner compartment door is removed.
• Warranty: 1-year OEM factory warranty. Orders ship same business day from our warehouse when placed before 3 PM EST.

Compatibility: Engineered specifically for the Carrier PG9MAB060080AASA gas furnace. Always verify your unit's OEM part number on the data plate or existing sensor before ordering. Not sure if this is the right fit? Our HVAC parts specialists are available to confirm compatibility before you buy — no guesswork, no returns.