OEM Carrier Hot Surface Igniter LH33ZG001 for Model PG9MAB036060ABSA

This is the genuine OEM hot surface igniter (part number LH33ZG001) factory-specified for the Carrier PG9MAB036060ABSA packaged gas unit. During every heating cycle, the control board energizes this igniter to reach the high temperature needed to light the gas burner. When it fails — due to normal aging, cracking, or oil contamination from handling — the furnace will attempt ignition, fail to sense a flame, and lock out, leaving you with no heat. Replacing this igniter with the OEM part restores reliable, factory-matched ignition performance.

• Specs: 120V hot surface igniter | Silicon nitride element | Kyocera-manufactured OEM component | Factory-matched element resistance and warm-up timing | Plug-and-play harness connector
• OEM vs Generic: OEM silicon nitride igniters from Carrier meet exact resistance tolerances and warm-up timing calibrated to the PG9MAB036060ABSA control board. Aftermarket units may vary in resistance, causing nuisance lockouts or premature failure — especially in cold-start conditions.
• Install Difficulty: 2/5 — De-energize the unit at the disconnect before servicing. Never touch the ceramic element with bare hands — skin oils cause hot spots and premature cracking. Tools needed: 1/4" nut driver, needle-nose pliers. Photograph wire harness connections before disconnecting. Confirm ignition sequence restores after replacement.
• Warranty: 1-year OEM factory warranty against defects. In-stock and ships same business day from our warehouse.

Compatibility: Engineered as the direct OEM replacement for the Carrier PG9MAB036060ABSA packaged gas heating unit. Always verify part number LH33ZG001 against your unit's data plate or parts list before ordering. Our fitment team is available to confirm compatibility before you buy — no guesswork, no return hassle.