OEM Carrier Flame Sensor LH680013 for Model PG9MAA060120ABKA

This OEM flame sensor (part number LH680013) is the factory-specified replacement for the Carrier PG9MAA060120ABKA gas furnace. The flame sensor is a critical safety component — it passes a small electrical current through the burner flame to confirm ignition. When the sensor rod is coated in oxidation or fails entirely, the control board cannot verify a live flame and shuts off the gas valve within 5–8 seconds of ignition as a safety measure, causing a frustrating no-heat short-cycle condition.

• Specs: OEM part number LH680013 | Single-rod flame sensor | Factory-matched resistance and rod geometry | 1/4" spade terminal connector
• OEM vs Generic: This is a genuine Carrier OEM flame sensor, manufactured to exact factory tolerances for rod length, ceramic insulator rating, and signal sensitivity. Generic sensors can misread the flame signal, causing nuisance lockouts or, worse, delayed shutdowns — always prefer OEM for a safety-critical component.
• Install difficulty: 2/5 — Turn off power and gas supply before beginning. Tools needed: 1/4" hex driver or nut driver, fine steel wool or emery cloth (for rod cleaning if reusing), multimeter. Note the wire orientation before disconnecting the spade terminal.
• Warranty: 1-year OEM factory warranty. Ships same business day from our warehouse when ordered before 3 PM local time.

Compatibility: Engineered as a direct OEM drop-in for the Carrier PG9MAA060120ABKA gas furnace. Verify your existing part number against LH680013 on your unit's wiring diagram or data label before ordering. Not sure it fits? Contact our HVAC parts specialists — we verify fitment before you buy. In stock and ships today.