OEM Carrier Hot Surface Igniter LH33ZG001 for Model PG95SAS60120DBAA

This is the genuine OEM hot surface igniter (part number LH33ZG001) factory-specified for the Carrier PG95SAS60120DBAA 95% AFUE gas furnace. The hot surface igniter is the first component activated on every call for heat — the control board energizes it to reach ignition temperature (roughly 1,800–2,100°F), at which point the gas valve opens and the burners light. A failed igniter is one of the most common causes of a no-heat service call: the furnace will attempt ignition, fail to sense a flame, and lock out — leaving you with a blinking fault code and a cold house.

• Specs: 120V AC input | Silicon nitride element | OEM part number LH33ZG001 | Lightweight 0.07 lb form factor | Factory-matched connector and bracket geometry for direct plug-in replacement
• OEM vs Generic: OEM silicon nitride igniters from Carrier are manufactured to precise resistance and thermal-cycle tolerances. Aftermarket igniters may use lower-grade elements that crack prematurely under thermal stress, leading to repeat failures within a single heating season.
• Install difficulty: 2/5 — Shut off power and gas before beginning. Tools needed: 1/4" nut driver, needle-nose pliers. Critical: never touch the ceramic igniter element with bare hands — skin oils cause hot spots that crack the element. Use gloves or handle only by the mounting bracket and harness connector.
• Warranty: 1-year OEM factory warranty. In-stock orders ship same business day from our warehouse when ordered before cut-off time.

Compatibility: Direct OEM replacement for Carrier PG95SAS60120DBAA packaged gas furnace units. Always verify the part number on your existing igniter or in your unit's service parts list before ordering. Our fitment team is available to confirm compatibility before you buy — no guesswork, no costly returns.