OEM Carrier Gas Furnace Pressure Switch for PG95SAS60100CBAA

The pressure switch is the safety interlock that proves your Carrier PG95SAS60100CBAA furnace is venting properly before any gas is allowed to flow. When the inducer motor spins up it creates a negative draft that pulls this switch closed; only then does the control board permit the igniter to glow and the gas valve to open. If the switch fails open, sticks, or its sensing hose clogs with condensate, the furnace will try to start, hum from the inducer, then lock out with no heat — often flashing a pressure-switch fault code and short-cycling through repeated failed attempts. A switch stuck closed is worse, because it can let the sequence proceed with a blocked flue. Specs: This is a negative-pressure (vacuum) switch rated in inches of water column. Carrier furnaces in this family use set points in the rough range of -0.40 to -1.00 in. w.c., with normally-open contacts that close on draft. You can confirm operation with a manometer on the inducer tap and a multimeter for continuity across the terminals. Single-stage and two-stage variants are NOT interchangeable, so match the set point and stage count on the original switch body. OEM vs Generic: This is a code-listed safety component, not a generic switch. An aftermarket switch with a different trip point may refuse to close on a healthy draft (nuisance no-heat lockouts) or, far worse, close too easily and allow burner operation during a partial vent blockage — the exact failure the switch exists to prevent. OEM switches hold their calibrated set point over thousands of cycles. Install: Difficulty 2 out of 5. Tools: 1/4-inch nut driver and a multimeter. SAFETY: shut off the gas supply and kill the furnace breaker first, and reconnect the sensing hose to the correct port with no kinks or low spots that trap water. Ships same business day from our stocked warehouse on orders before 3 PM CST. Backed by a 1-year OEM warranty and 30-day hassle-free returns on uninstalled parts.

Compatibility

This part is compatible with Carrier model PG95SAS60100CBAA. Always verify the part number against your unit's data plate before ordering.

Why Choose OEM?

OEM parts are manufactured to the exact factory specifications for your unit. Generic aftermarket alternatives may fit physically but often use lower-rated components that reduce equipment life and void manufacturer warranties. When the cost difference between OEM and generic is $10-30, the OEM part is always the smarter investment on a system worth $5,000-$15,000.

Shipping & Returns

Same-day shipping on orders before 3 PM CST. Standard delivery 2-5 business days, express options available at checkout. 30-day hassle-free returns on uninstalled parts — free return shipping included. 1-year OEM factory warranty coverage.