OEM Carrier Hot Surface Igniter LH33ZG001 for Model PG92SAS60120DAAA

This is the genuine OEM hot surface igniter (part# LH33ZG001) factory-specified for the Carrier PG92SAS60120DAAA 92% AFUE packaged gas unit. The igniter is the first component activated during every heating cycle — the control board energizes it to reach ignition temperature, at which point the gas valve opens and the burner lights. When the igniter fails, the furnace will attempt ignition, fail to sense flame, and enter a safety lockout — leaving you with no heat. Common symptoms include a system that runs the inducer and blower but never produces heat, or a system that locks out after 3 ignition attempts.

• Specs: 120V hot surface igniter | Silicon nitride element | Includes mounting bracket and wiring harness | Factory-matched to Carrier LH33ZG001 specification
• OEM vs Generic: OEM igniters are manufactured to exact Carrier tolerances for element resistance, warm-up time, and mechanical fit. Aftermarket igniters often vary in warm-up time, causing nuisance lockouts or premature element cracking due to thermal stress mismatches.
• Install difficulty: 2/5 — Shut off gas and power before beginning. Tools needed: 1/4" nut driver, needle-nose pliers. Never touch the igniter element with bare hands — skin oils cause hot spots and dramatically shorten element life. Always verify the ignition sequence with a multimeter after installation.
• Warranty: 1-year OEM factory warranty. Orders placed before 3 PM ship same business day from our warehouse.

Compatibility: Designed as a direct OEM replacement for the Carrier PG92SAS60120DAAA packaged gas unit. Verify your unit's part number against LH33ZG001 on the data plate or wiring diagram before ordering. Need fitment confirmation? Our HVAC parts specialists are available to verify compatibility before you buy — order today and get your heat back fast.