OEM Carrier Hot Surface Igniter for Gas Furnace PG8UAA060155ADJA

The hot surface igniter is the component that lights the burners on every heat call. When the thermostat asks for heat, the control board sends voltage to the igniter, which glows orange-hot in a few seconds; gas is then released across it and ignites. Igniters are brittle and degrade with every thermal cycle until they finally crack or no longer reach ignition temperature. The homeowner symptom is no heat while the blower and inducer run normally — you may hear the gas valve click and even catch a brief whiff of unburned gas before the board locks out, often after three failed ignition attempts. A common tell is the furnace blowing cold air and then shutting down. This genuine Carrier hot surface igniter is matched to the furnace's ignition control. Modern OEM igniters use durable silicon nitride, which is far more rugged and crack-resistant than older silicon carbide elements; cold resistance typically reads in the range of roughly 40 to 75 ohms (an open or infinite reading means a cracked element that must be replaced). OEM matters because the control board is tuned to the igniter's specific resistance and warm-up curve. Generic igniters with the wrong resistance may not glow hot enough to ignite gas reliably, or they draw the wrong current and fail early. The correct OEM part reaches full ignition temperature on schedule and survives far more cycles. Installation difficulty: 2 of 5. Tools needed: a 1/4-inch nut driver and a multimeter for the resistance check. Handle the new igniter only by its ceramic base — skin oils weaken the element. #1 safety warning: shut off the gas supply and kill power to the furnace before servicing. Ships same business day from our stocked warehouse on orders placed before 3 PM CST. Backed by a 1-year OEM warranty and 30-day hassle-free returns on uninstalled parts.

Compatibility

This part is compatible with Carrier model PG8UAA060155ADJA. Always verify the part number against your unit's data plate before ordering.

Why Choose OEM?

OEM parts are manufactured to the exact factory specifications for your unit. Generic aftermarket alternatives may fit physically but often use lower-rated components that reduce equipment life and void manufacturer warranties. When the cost difference between OEM and generic is $10-30, the OEM part is always the smarter investment on a system worth $5,000-$15,000.

Shipping & Returns

Same-day shipping on orders before 3 PM CST. Standard delivery 2-5 business days, express options available at checkout. 30-day hassle-free returns on uninstalled parts — free return shipping included. 1-year OEM factory warranty coverage.