OEM Carrier Hot Surface Igniter Kit 332505-751 for Model PG8UAA024065AAJA

This is the factory OEM hot surface igniter replacement kit (part number 332505-751) for the Carrier PG8UAA024065AAJA gas furnace. The hot surface igniter is the component that glows to ignition temperature — typically between 1,800°F and 2,200°F — to light the gas burner at the start of every heat cycle. When it fails, the furnace control board attempts ignition, detects no flame, and locks out, leaving you with no heat. Common symptoms include the inducer starting normally, followed by a lockout fault code after one or two failed ignition attempts.

• Specs: 120V hot surface igniter | Silicon carbide element | Includes OEM mounting bracket and pre-wired harness | Factory-matched for Carrier PG8UAA024065AAJA
• OEM vs Generic: OEM igniters are manufactured to exact wattage and resistance tolerances for your specific control board's timing sequence. Generic igniters may draw inconsistent current, causing nuisance lockouts or premature cracking of the element.
• Install difficulty: 2/5 — Power off the furnace and allow the igniter to cool completely before handling. Never touch the ceramic element with bare hands — skin oils cause hot spots and early failure. Tools needed: 1/4" nut driver, needle-nose pliers. Disconnect the harness connector, remove the single mounting screw, and reverse for installation.
• Warranty: 1-year OEM manufacturer warranty against defects. In-stock and ships same business day from our warehouse.

Compatibility: Engineered as the direct OEM replacement for the Carrier PG8UAA024065AAJA gas furnace. Also cross-references Bryant and Payne units sharing part number 1176919. Verify your existing igniter's voltage rating (120V) against your unit's data plate before ordering. Our fitment team is available to confirm compatibility prior to purchase — no guesswork required.