OEM Carrier Hot Surface Igniter LH33ZG001 for Model PG8MEA060110ACJA

This is the genuine OEM hot surface igniter (part number LH33ZG001) for the Carrier PG8MEA060110ACJA packaged gas unit. The igniter is the critical first step in every heating cycle — it heats to approximately 2,000°F to ignite the gas burner on each call for heat. When it fails, the control board will attempt ignition, fail to sense flame, and lock out the unit, leaving you with a system that runs the inducer but delivers no heat. Common failure signs include a hard lockout error code, a visibly cracked igniter element, or a furnace that clicks through its ignition sequence and then shuts down completely.

• Part Number: LH33ZG001 | OEM Carrier replacement | Includes mounting bracket and wiring harness for direct plug-in installation
• OEM vs Generic: This is a factory-matched OEM igniter, not an aftermarket substitute. Generic igniters often vary in element resistance and geometry, which can cause nuisance lockouts or premature failure. OEM ensures exact fit, correct wattage draw, and full compatibility with the PG8MEA060110ACJA control board ignition sequence.
• Install difficulty: 2/5 — Disconnect power and gas before servicing. Allow the igniter to cool completely before handling — the silicon nitride element is extremely fragile. Avoid all skin contact with the element (oils cause premature failure). Tools needed: 1/4" nut driver, needle-nose pliers. Unplug harness, remove mounting screw, swap igniter, reconnect. Verify ignition on first call for heat.
• Warranty: 1-year OEM manufacturer warranty. In-stock and ships same business day from our warehouse.

Compatibility: Factory-specified replacement for Carrier model PG8MEA060110ACJA packaged gas heating unit. Verify your existing part number on the unit's service label before ordering. Have questions about fitment? Our HVAC parts specialists confirm compatibility before you buy — same-day shipping available on all in-stock orders.