OEM Carrier Hot Surface Igniter LH33ZG001 for Model PG8MEA060110AAJA

This is the factory OEM hot surface igniter (part number LH33ZG001) for the Carrier PG8MEA060110AAJA packaged gas unit. The igniter is the first component activated during every heating cycle — the control board energizes it to glow at over 1,800°F, igniting the gas burner. When it fails, the control board detects no flame after the ignition attempt and locks the unit out, resulting in a no-heat call. Common symptoms include a furnace that attempts to start, clicks through the ignition sequence, then shuts off and flashes a fault code — often a 3-flash or 4-flash ignition lockout sequence.

• Specs: 120V AC | Silicon nitride element (preferred over silicon carbide for durability) | Factory-matched resistance and warm-up time | Includes wiring harness connector for plug-and-play installation
• OEM vs Generic: OEM igniters from Carrier are calibrated to the exact resistance profile and warm-up curve required by the PG8MEA060110AAJA control board. Off-spec generic igniters may glow too slowly or draw excess current, causing nuisance lockouts or premature element failure.
• Install difficulty: 2/5 — Shut off power and gas before beginning. Tools needed: 1/4" nut driver, needle-nose pliers. Do not touch the igniter element with bare hands — skin oils cause hot spots that crack the element under heat. Handle only by the ceramic bracket or wiring harness.
• Warranty: 1-year OEM factory warranty against defects. Orders ship same business day from our warehouse.

Compatibility: Designed for the Carrier PG8MEA060110AAJA packaged gas unit. Verify part number LH33ZG001 against your unit's service parts list or data plate before ordering. Not sure it fits? Our HVAC parts specialists confirm fitment before you buy — no guesswork, no returns.