OEM Carrier Gas Furnace Flame Sensor Rod for PG8MAA060155AAJA

The flame sensor is a single metal rod that sits in the burner flame and confirms the furnace actually lit. It works by flame rectification: the control board sends a small AC voltage down the rod, and the ionized flame conducts a tiny DC microamp signal back to ground. If the board doesn't see that current within a few seconds of the gas valve opening, it shuts the gas off as a safety. A dirty or worn sensor is the single most common cause of a Carrier furnace that lights for a few seconds, then shuts down and tries again — the classic short-cycle on a call for heat, sometimes locking out after three tries with no heat. This OEM Carrier flame sensor uses the correct rod length, bend, and Kanthal/stainless alloy to sit precisely in the flame envelope of the PG8MAA060155 burner. Position matters: a rod that sits too high or low reads a weak signal even when clean. A healthy sensor on this furnace typically returns roughly 2 to 6 microamps DC; below about 0.5 µA the board will refuse to stay lit. Generic flame rods are often stamped from thinner, lower-grade steel that oxidizes faster, so the silicon-oxide film that kills the microamp signal builds back up within months. The OEM rod's alloy and geometry hold a stable flame-rectification signal far longer. Installation difficulty: 1 of 5. Tools: 1/4-inch nut driver and fine steel wool or emery cloth (to clean, not replace, if it is only dirty); a multimeter set to DC microamps confirms the new reading. SAFETY: turn off the gas supply and the 120V power before removing the sensor at the burner assembly. Ships same business day from our stocked warehouse on orders before 3 PM CST. 1-year OEM warranty and 30-day hassle-free returns on uninstalled parts.

Compatibility

This part is compatible with Carrier model PG8MAA060155AAJA. Always verify the part number against your unit's data plate before ordering.

Why Choose OEM?

OEM parts are manufactured to the exact factory specifications for your unit. Generic aftermarket alternatives may fit physically but often use lower-rated components that reduce equipment life and void manufacturer warranties. When the cost difference between OEM and generic is $10-30, the OEM part is always the smarter investment on a system worth $5,000-$15,000.

Shipping & Returns

Same-day shipping on orders before 3 PM CST. Standard delivery 2-5 business days, express options available at checkout. 30-day hassle-free returns on uninstalled parts — free return shipping included. 1-year OEM factory warranty coverage.