OEM Carrier Flame Sensor with Wire (LH680014) for Model PG8MAA060090ADJA

This is the OEM factory-specified flame sensor with wire for the Carrier PG8MAA060090ADJA 80% efficiency gas furnace. The flame sensor is a critical safety component — its flame rod detects whether a burner flame is actually present after ignition. When the sensor fails or becomes coated with oxidation, the furnace control board cannot confirm combustion, triggering a safety shutoff. The telltale symptom: the burner lights normally, runs for 5–8 seconds, then cuts out — often repeating in a lockout sequence.

• Specs: 45-degree flame rod orientation | Includes factory lead wire | High-temperature kanthal flame rod material | Alumina ceramic insulator | OEM Part No. LH680014 | Replaces LH33WZ511, LH33WZ515, LH33WZ517, LH680012
• OEM vs Generic: This genuine Carrier OEM sensor is factory-matched to the PG8MAA060090ADJA control board's microamp sensing threshold. Generic sensors can produce inconsistent microamp readings, causing nuisance lockouts or masking true combustion faults.
• Install difficulty: 1/5 — One of the easiest furnace repairs. Tools needed: 1/4" hex driver or nut driver, needle-nose pliers. Turn off power and gas before servicing. Disconnect the lead wire, remove the single mounting screw, swap the sensor, and reconnect. Always clear any fault codes after replacement.
• Warranty: 1-year OEM factory warranty. Ships same business day from our warehouse when ordered before 3 PM local time.

Compatibility: Designed as the factory replacement for Carrier PG8MAA060090ADJA 80% AFUE gas furnaces. Cross-references: LH33WZ511, LH33WZ515, LH33WZ517, LH680012, LH680534. Verify your existing sensor's mounting angle and wire length before ordering. Our fitment team is available to confirm compatibility — just reach out before you buy. In stock and ships today.