OEM Carrier Hot Surface Igniter LH33ZG001 for Model PG8JVB066135AAJA

This is the factory OEM hot surface igniter (part # LH33ZG001) for the Carrier PG8JVB066135AAJA packaged gas unit. During every heating cycle, the control board energizes this igniter to glow at temperatures exceeding 1,800°F, igniting the gas burner. When it fails — through cracking, contamination, or element burnout — the furnace will attempt ignition, fail to sense flame, and lock out after 1–3 tries, leaving you with no heat. A failed igniter is one of the most common causes of furnace no-heat calls in the field.

• Specs: 120V AC | Silicon nitride element | OEM part # LH33ZG001 | Weight: 0.07 lbs | Factory plug-and-play connector
• OEM vs Generic: This is the genuine Carrier OEM igniter, manufactured to exact factory resistance and wattage tolerances. Aftermarket igniters often run outside spec, causing nuisance lockouts or premature failure within one season.
• Install Difficulty: 2/5 — Always de-energize the unit at the disconnect before starting. Avoid touching the ceramic element with bare hands — skin oils cause hot spots and early failure. Tools needed: 1/4" nut driver, flat-head screwdriver, needle-nose pliers. Swap takes approximately 20–30 minutes.
• Warranty: 1-year OEM factory warranty against defects. In-stock and ships same business day from our warehouse.

Compatibility: Engineered as the direct OEM replacement for the Carrier PG8JVB066135AAJA packaged gas heating unit. Always verify the part number on your unit's data plate or wiring diagram before ordering. Need fitment confirmation? Our HVAC parts specialists verify compatibility before you buy — order with confidence.