OEM Carrier Hot Surface Igniter LH33ZG001 for Model PG8JEA060135ACJA

This is the genuine OEM hot surface igniter (part number LH33ZG001) factory-specified for the Carrier PG8JEA060135ACJA packaged gas unit. The hot surface igniter is the critical first step in every heating cycle — the control board energizes it to glow at extreme temperatures, igniting the gas burners within seconds. When the igniter fails, the furnace will attempt ignition, fail to light the burners, and enter a hard lockout — leaving your system blowing cold air or displaying a fault code. A cracked, contaminated, or electrically open igniter is one of the most common causes of no-heat calls.

• Specs: 120V hot surface igniter | Silicon nitride element | OEM part number LH33ZG001 | Factory-matched resistance and wattage for reliable cold-weather starts
• OEM vs Generic: Genuine Carrier OEM igniters are manufactured to exact resistance tolerances, ensuring the control board's timing sequence fires correctly every cycle. Generic igniters can vary in wattage and element geometry, leading to nuisance lockouts or premature failure — especially in cold climates where igniter draw is highest.
• Install Difficulty: 2/5 — Shut off power and gas before beginning. Allow the old igniter to cool completely — never touch the element with bare hands, as skin oils cause premature cracking. Tools needed: 1/4" nut driver, needle-nose pliers, phone/camera to photograph wire harness routing before disconnecting. Average install time: 20–30 minutes.
• Warranty: 1-year OEM manufacturer warranty against defects. Ships same business day from our warehouse when ordered before cutoff.

Compatibility: Engineered as the direct OEM replacement for Carrier PG8JEA060135ACJA packaged gas heating units. Always cross-reference the part number on your existing igniter or the unit's parts list before ordering. Need help confirming fitment? Our HVAC parts specialists verify compatibility before you buy — order with confidence and get back to heat fast.