OEM Carrier Silicon Nitride Hot Surface Igniter LH33ZG001 for Model PG8JEA060110ABJA

This is the factory-authorized OEM hot surface igniter (part number LH33ZG001) for the Carrier PG8JEA060110ABJA packaged gas unit. The igniter is the first component to activate during every heating cycle — it heats to over 2,000°F in seconds to ignite the gas burner. When it fails, the furnace will attempt ignition, fail to light, and enter a safety lockout, leaving you with no heat. Common symptoms include the inducer running, a pause, then the system shutting down after 3 attempts with a lockout fault code.

• Specs: Silicon Nitride element | 120V rated | Room temp resistance: 45–70 Ohms | Steady-state current: 4.25–4.75A @ 132V | Element length: 3/16" | Total length with base: 2-1/2" | Wire length: 9-1/4" | Bracket length: 1-1/4" | Manufactured in Japan by Kyocera
• OEM vs Generic: This OEM Carrier LH33ZG001 is factory-matched for the PG8JEA060110ABJA's ignition control timing and current draw. Generic silicon nitride igniters often fall outside the required resistance window, causing nuisance lockouts or premature failure within one heating season.
• Install difficulty: 2/5 — Shut off gas and power before beginning. Tools needed: 1/4" nut driver, flat-head screwdriver. Critical: Handle by the ceramic base only — never touch the silicon nitride element. Skin oils cause hot spots that crack the element under thermal stress, leading to immediate or early failure.
• Warranty: 1-year OEM manufacturer warranty against defects. In-stock and ships same business day from our warehouse.

Compatibility: Designed for the Carrier PG8JEA060110ABJA packaged gas heating unit. Also fits compatible Bryant and Payne models specifying OEM part number LH33ZG001. Verify your existing igniter's part number or resistance spec against your unit's service manual before ordering. Need fitment confirmation? Our HVAC parts specialists are standing by.