OEM Carrier Hot Surface Igniter LH33ZG001 for Model PG8JEA060110AAJA

This is the genuine OEM hot surface igniter (part number LH33ZG001), factory-specified for the Carrier PG8JEA060110AAJA packaged gas unit. On every call for heat, the control board energizes this igniter to reach ignition temperature — typically around 1,800°F — before opening the gas valve. When the igniter fails, the furnace will attempt to light, fail to establish a flame, and lock out after one to three tries. Common symptoms include a no-heat call, a flashing fault code on the control board, or a system that starts briefly and then shuts off without ever producing heat.

• Specs: 120V AC | Silicon nitride element | OEM part number LH33ZG001 | Factory-matched geometry and lead wire harness for direct plug-in replacement
• OEM vs Generic: Genuine Carrier OEM igniters are manufactured to exact resistance and fragility tolerances. Aftermarket igniters frequently run hotter or cooler than spec, causing nuisance lockouts or premature cracking — OEM is the only guaranteed drop-in fit for the PG8JEA060110AAJA.
• Install difficulty: 2/5 — Shut off power and gas before servicing. Allow the igniter to cool completely before handling — never touch the ceramic element with bare hands, as skin oils cause thermal stress fractures. Tools needed: 1/4" nut driver, needle-nose pliers. Disconnect the harness plug, remove the single mounting screw, swap the igniter, and verify ignition on the next heat cycle.
• Warranty: 1-year OEM factory warranty. In-stock orders ship same business day from our warehouse.

Compatibility: Engineered for the Carrier PG8JEA060110AAJA packaged gas heating unit. Always cross-reference your unit's data plate and parts schematic to confirm LH33ZG001 is the specified igniter before ordering. Our HVAC parts specialists are available to verify fitment — contact us before you order if you have any questions.