OEM Carrier Flame Sensor with Wire LH680014 for Model PG8JAA036110ACJA

This OEM flame sensor with wire (part number LH680014) is the factory-specified replacement for the Carrier PG8JAA036110ACJA packaged gas furnace. The flame sensor is a safety device — a metal rod that confirms the presence of a burner flame by passing a small microamp current through it to the control board. When it becomes coated with oxidation or carbon buildup, or when it fails entirely, the furnace will light briefly and then shut down within 5–8 seconds, triggering a lockout condition. This is one of the most common causes of a furnace that "ignites but won't stay on."

• Specs: OEM flame rod with pre-attached wire harness | Factory-matched microamp sensitivity | Correct mounting bracket geometry for PG8JAA036110ACJA burner assembly | Plug-and-play wire connector for direct board connection
• OEM vs Generic: This is the genuine Carrier OEM part — not an aftermarket substitute. OEM flame sensors maintain the precise rod composition and microamp threshold required by the factory control board. Generic sensors can trigger nuisance lockouts or fail to meet safety ratings.
• Install difficulty: 2/5 — Turn off gas supply and 120V power before beginning. Tools needed: 1/4" hex driver or nut driver, needle-nose pliers. Disconnect wire harness, remove mounting screw, swap sensor, reconnect harness. Clear any fault codes after installation.
• Warranty: 1-year OEM manufacturer warranty. In-stock and ships same business day from our warehouse.

Compatibility: Engineered for the Carrier model PG8JAA036110ACJA packaged gas furnace. Verify your unit's existing flame sensor mounting configuration and wire harness connector before ordering. Have questions about fitment? Our HVAC parts specialists confirm compatibility before you buy — no guesswork.