OEM Carrier Hot Surface Igniter Kit 332505-751 for Model PG8DAA048095ACJA

This is the OEM factory-authorized hot surface igniter replacement kit for the Carrier PG8DAA048095ACJA gas furnace. The hot surface igniter is the component responsible for lighting the gas burners on every heating cycle. When it fails — due to cracking, oxidation, or electrical burnout — the furnace will attempt ignition, fail to light, and enter a safety lockout, leaving you with no heat. If your furnace tries to start but shuts down after 30–90 seconds with a lockout fault code, a failed igniter is one of the most common culprits.

• Specs: 120V hot surface igniter | Silicon nitride element | Includes mounting bracket, wire harness, and plug connector | OEM part number 332505-751 (also cross-references LH33ZG001)
• OEM vs Generic: This is a genuine Factory Authorized Parts kit — not an aftermarket substitute. OEM igniters are precision-matched to your furnace's ignition control timing sequence. Generic igniters often vary in resistance and warm-up time, causing nuisance lockouts and premature board wear.
• Install difficulty: 2/5 — Shut off gas supply and power before beginning. Tools needed: 1/4" nut driver, needle-nose pliers. Disconnect the old igniter's wire harness, unscrew the mounting bracket, and reverse the process to install. Avoid touching the silicon nitride element with bare hands — skin oils cause premature failure. Allow the furnace to complete a full ignition cycle to verify repair.
• Warranty: 1-year OEM factory warranty. In stock and ships same business day from our warehouse.

Compatibility: Designed as the direct OEM replacement for Carrier PG8DAA048095ACJA gas furnaces. Always verify your furnace model and existing igniter voltage (120V) against the data plate located inside the furnace cabinet before ordering. Our parts specialists are available to confirm fitment before you buy — no guesswork required.