OEM Carrier Hot Surface Ignitor Kit 332505-751 for Model PG8DAA036095ABJA

This is the factory-authorized OEM hot surface ignitor replacement kit for the Carrier PG8DAA036095ABJA gas furnace. The hot surface ignitor is a critical component in your furnace's ignition sequence — when the thermostat calls for heat, the ignitor heats to over 1,800°F to light the gas burners. A failed ignitor is one of the most common causes of a no-heat call: the furnace will attempt ignition, fail to sense a flame, and lock out — typically within 30–90 seconds of the heating cycle starting. This OEM kit (part number 332505-751, cross-references ignitor LH33ZG001) includes the ignitor element and mounting hardware accessories for a complete, factory-matched repair.

• Specs: 120V hot surface ignitor | Silicon nitride element | Includes mounting bracket and wiring harness | Factory Authorized Parts (FAP) kit — direct OEM fit for Carrier PG8DAA036095ABJA
• OEM vs Generic: OEM ignitors are manufactured to exact factory tolerances for resistance, warm-up time, and element geometry. Generic igniters often run off-spec, leading to incomplete ignition, nuisance lockouts, or premature cracking of the brittle silicon nitride element.
• Install Difficulty: 3/5 — Power down and lock out the furnace before starting. Tools needed: 1/4" and 5/16" nut drivers, needle-nose pliers. Handle the ignitor element with care — skin oils can cause premature failure. Do not touch the ceramic element with bare hands.
• Warranty: 1-year OEM factory warranty on parts. In-stock and ships same business day from our warehouse.

Compatibility: Designed for the Carrier PG8DAA036095ABJA gas furnace. This kit is also used across the Carrier, Bryant, and Payne furnace families that share the LH33ZG001 ignitor specification — always verify your model and existing part number against your unit's data plate before ordering. Need help confirming fitment? Our HVAC parts specialists are standing by.