OEM Carrier Condenser Fan Motor HC31GE234 for Model CA13NA01800GADAA

This is the factory OEM condenser fan motor (part number HC31GE234) for the Carrier CA13NA01800GADAA split-system air conditioner. The condenser fan motor drives the outdoor fan blade to pull air across the condenser coil, dissipating heat from the refrigerant. When this motor fails, the outdoor unit may run briefly then shut down on high-pressure lockout, blow warm air, or the condenser fan may stop spinning entirely while the compressor continues running — a situation that can cause costly compressor damage if left unaddressed.

• Specs: 1/4 HP | 208–230V | Factory-matched RPM and rotation direction | Correct shaft diameter for OEM fan blade | ±5% tolerance windings for reliable starting in high-heat conditions
• OEM vs Generic: OEM motors are wound and balanced to Carrier's exact factory specification, ensuring correct airflow, amp draw, and bearing life. Generic motors may use mismatched RPM or rotation, reducing system efficiency and risking premature failure of the compressor.
• Install Difficulty: 3/5 — Disconnect power and verify zero voltage before beginning. Tools needed: 1/4" and 5/16" nut drivers, wire nuts or spade connectors, multimeter, and a fan blade puller (recommended). Photograph all wiring and note blade pitch/orientation before removal. Capacitor should be tested or replaced at the same time.
• Warranty: 1-year OEM factory warranty against defects. In-stock units ship same business day when ordered before cutoff.

Compatibility: Engineered specifically for the Carrier CA13NA01800GADAA 1.5-ton single-stage R-410A split-system condenser. Always verify horsepower, voltage, RPM, rotation direction, and shaft diameter against your unit's data plate before ordering. Our fitment specialists are available to confirm compatibility before you purchase — same-day shipping available on all in-stock OEM motors.