Armstrong Air Furnace Error Codes - Complete Guide

Armstrong Air is owned by Lennox and uses the same control boards as Lennox, Aire-Flo, and Ducane. All four brands share single LED flash codes for fault diagnosis. Also covers Lennox, Aire-Flo, Ducane.

All Armstrong Air Error Codes

1 flash

Lennox 1 Flash — Flame Sensed With Gas Valve Off

Flame detected when gas valve should be closed.

2 flashes

Lennox 2 Flashes — Closed Pressure Switch With Inducer Off

Pressure switch stuck closed when inducer is off.

3 flashes

Lennox 3 Flashes — Open Pressure Switch With Inducer On

Pressure switch open during inducer operation — vent blockage or bad switch.

4 flashes

Lennox 4 Flashes — Primary Limit Switch Open

Primary limit switch open — overheating. Usually restricted airflow.

5 flashes

Lennox 5 Flashes — Roll Out Switch Open (SAFETY)

Roll out switch tripped — possible cracked heat exchanger and CO risk.

6 flashes

Lennox 6 Flashes — Pressure Switch System Lockout

Persistent pressure switch errors caused lockout.

7 flashes

Lennox 7 Flashes — Burners Failed to Ignite Lockout

Burners failed to ignite — locked out after retries.

8 flashes

Lennox 8 Flashes — Burners Lost Flame Too Many Times

Flame established but kept dropping out — usually flame sensor.

9 flashes

Lennox 9 Flashes — Line Voltage Polarity Incorrect

Line voltage polarity reversed — wiring or grounding issue.

Need Help With Something Else?

If you don't see your code here, try our master error code lookup covering all major brands, or our symptom-based diagnostic tool.

Browse Armstrong Air parts inventory.

Menu

Armstrong Air Furnace Error Codes - Complete Guide

All Armstrong Air Error Codes

Need Help With Something Else?