OEM Goodman Low Pressure Switch for DCH060XXX4BJXHAC — 0130M00075

The Goodman 0130M00075 is a genuine OEM low pressure switch designed as a direct replacement for the DCH060XXX4BJXHAC packaged unit and compatible Goodman/Amana equipment. This control monitors refrigerant suction pressure and opens the circuit if pressure drops too low — protecting the compressor from a loss-of-charge, restricted metering device, or low-airflow condition. A stuck-open switch causes no-cool complaints and lockouts, while a stuck-closed switch removes critical protection; installing the exact factory part restores correct operation.

• Function: Low pressure / loss-of-charge safety cut-off
• Circuit: Normally closed, opens on low suction pressure
• OEM Part Number: 0130M00075
• Brand: Goodman (also fits Amana)
• Equipment: Packaged furnace / condensing unit
• Fit: Direct OEM replacement

OEM vs. Generic: The genuine 0130M00075 is calibrated to Goodman's factory cut-out and cut-in setpoints, ensuring the compressor is protected without nuisance trips. Generic substitutes often use approximate setpoints that either lock the system out prematurely or fail to protect against low charge, so OEM is the recommended choice for this safety control.

Install difficulty: Easy to moderate — about 15–25 minutes. Disconnect power, isolate or recover refrigerant as required by the port type, remove the spade leads, replace the switch on its suction-line fitting with the proper gasket or Schrader connection, and reconnect the wiring. Leak-check and confirm the switch closes under normal suction pressure. Observe EPA refrigerant-handling rules.