ICP Round Run Capacitor 2.0 MFD for WPG3304060RKC1 — With Clamp | Ships Today

Overview

This OEM 2.0 MFD round run capacitor (P/N 1095021) with its mounting clamp provides the steady phase-shift current that keeps a fan or auxiliary motor running smoothly in your ICP Tempstar Heil WPG3304060RKC1. A capacitor is a wear item — over time it loses microfarad capacity, swells, or shorts out. A weak or dead capacitor is one of the most common causes of a motor that hums but won't start, runs hot, or trips on overload.

Specifications

Compatibility

Direct OEM replacement for the ICP Tempstar Heil WPG3304060RKC1 and related WPG-series units using a 2.0 MFD round capacitor. Verify the MFD rating and voltage stamped on your existing capacitor before installing.

Installation Guide

1. Safety First — Disconnect power and verify zero voltage with a multimeter. A capacitor stores charge — discharge it across a resistor before handling.
2. Access — Remove the control panel to expose the capacitor and its clamp.
3. Document — Photograph the wire terminals before disconnecting.
4. Remove — Pull the spade terminals, loosen the mounting clamp, and remove the old capacitor.
5. Install — Secure the new capacitor with the clamp and reconnect the wires per your photo.
6. Test — Restore power and confirm the motor starts and runs without humming or overheating.

Signs You Need a Replacement

• Motor hums but will not start
• Capacitor body is bulged, leaking, or domed on top
• Measured capacitance is well below the 2.0 MFD rating
• Motor runs hot or cycles on its overload

Shipping & Returns

Ships same day on orders placed before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.