ICP Integrated Control Board & Ignition Module for WPG3244060RKC1 — OEM | Ships Today

Overview

This OEM control set for the ICP/Tempstar/Heil WPG3244060RKC1 includes the integrated circuit board (PN 1178358) and ignition control module (PN 1177661). Together they manage the full heating sequence: inducer startup, pressure switch proving, hot surface igniter warm-up, gas valve timing, flame sensing, and blower on/off delays, along with the safety lockout logic. A failed board produces erratic symptoms — no ignition, blower that won't start or won't stop, repeated lockouts, or a completely dead control circuit despite good 24V power. Boards fail from voltage surges, flame-sensor feedback faults, cracked relays, and heat-related solder fatigue.

Specifications

Compatibility

Direct-fit OEM replacement for the ICP/Tempstar/Heil WPG3244060RKC1 packaged unit and Heil-family furnace sections using this control board and ignition module.

Installation Guide

1. Safety First — Disconnect power at the breaker, shut off the gas, and verify zero voltage with a multimeter.
2. Access — Remove the control/burner access panel.
3. Document — Photo every connector and wire harness on the board and module before disconnecting.
4. Remove — Unplug all connectors, remove the mounting screws/standoffs, and lift out the old board and module.
5. Install — Mount the new board and module, reseat every harness connector firmly per your photo, and confirm no pinched wires.
6. Test — Restore gas and power, run a full heat cycle, and verify ignition, flame proving, and blower timing.

Signs You Need a Replacement

• No ignition sequence despite confirmed 24V power
• Blower runs constantly or never engages
• Repeated hard lockouts with no clear cause
• Visible burnt traces, scorched relays, or cracked solder joints

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.