ICP Ignitor Electrode for RGS214LDAA0AAAA — Furnace Ignition | Ships Today

Overview

This OEM ignitor electrode (PN 1179966) is the ignition component responsible for lighting the burners in your ICP RGS214LDAA0AAAA gas furnace. On each heat call the electrode delivers the high-voltage source that ignites the gas at the burner, getting your furnace into its heating cycle reliably. Over time the electrode tip erodes, cracks, or carbons over, leading to failed ignition, repeated lockouts, or delayed light-off that produces a small "whump" at startup. Because ignition components endure intense heat thousands of cycles per season, a worn electrode is one of the most common no-heat service calls.

Specifications

Compatibility

Designed as a direct-fit replacement for the ICP/Tempstar/Heil model RGS214LDAA0AAAA gas furnace. Always confirm the electrode mounting bracket and lead routing match your existing part before installing.

Installation Guide

1. Safety First — Shut off gas and disconnect power at the furnace switch and breaker; verify zero voltage with a multimeter.
2. Access — Remove the furnace's burner-compartment service panel.
3. Document — Photograph the electrode position, gap, and wire routing before removing anything.
4. Remove — Disconnect the ignition lead and unscrew the old electrode from the burner assembly.
5. Install — Mount the new electrode, set it to the proper position over the burner, and reconnect the ignition lead per your photo.
6. Test — Restore gas and power, then run a full heat cycle to confirm clean, immediate ignition.

Signs You Need a Replacement

• Furnace fails to light or goes into ignition lockout
• Repeated retries before the burners light
• Delayed ignition with a noticeable "whump" at startup
• Visibly cracked, eroded, or carbon-fouled electrode tip

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.