ICP Hot Surface Igniter & Wiring Kit for RGS150HFAB0AGAA — OEM Ignitor | Ships Today

Overview

This genuine ICP ignition kit restores reliable heating on your RGS150HFAB0AGAA packaged gas/electric unit. It includes the hot surface igniter (part 1171306), which glows to ignite the burners on a call for heat, and the matching igniter wiring kit (part 1188370) with the correct connector and leads for a clean, no-splice replacement. Hot surface igniters are brittle and wear out with thermal cycling — a cracked or aged igniter is the leading cause of no-heat calls and short cycling on lockout. Installing the wiring kit alongside the igniter prevents recurring failures from corroded or heat-damaged connectors.

Specifications

Compatibility

Engineered for the ICP/Tempstar/Heil RGS150HFAB0AGAA packaged unit and related RGS-series models using a hot surface ignition system. The included wiring kit ensures a correct connector match for your control board harness.

Installation Guide

1. Safety First — Shut off gas and disconnect electrical power. Verify zero voltage with a multimeter.
2. Access — Remove the burner compartment service panel.
3. Document — Photograph the igniter position and harness routing before disconnecting.
4. Remove — Unplug the old igniter at the connector and unfasten its mounting screw. Handle only by the ceramic base — never touch the element.
5. Install — Mount the new igniter at the correct gap to the burner, then install the new wiring kit and plug into the control board.
6. Test — Restore gas and power, start a heat cycle, and confirm the igniter glows and the burners light promptly.

Signs You Need a Replacement

• No heat or furnace locking out on failed ignition
• Igniter not glowing on a call for heat
• Visible cracks or breaks in the ceramic element
• Short cycling or repeated ignition retries

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. National HVAC Parts fitment guarantee.