ICP Hot Surface Igniter & Wiring Kit for RGS150HDCB0AAAA — OEM Ignitor | Ships Today

Overview

This genuine OEM hot surface igniter (P/N 1171306) with matching wiring kit (P/N 1188370) for the ICP Tempstar Heil RGS150HDCB0AAAA furnace lights the burners on each call for heat. When the gas valve opens, the igniter glows red-hot to ignite the gas-air mixture. Hot surface igniters are brittle and wear out over time — repeated heating cycles cause hairline cracks, and oil or dust contamination weakens the element until it fails to reach ignition temperature. The included wiring kit provides a fresh harness/connector so corroded or heat-damaged leads don't compromise the new igniter. A bad igniter is the leading cause of no-heat calls and furnace lockouts.

Specifications

Compatibility

Designed for the ICP Tempstar Heil RGS150HDCB0AAAA gas furnace and related ICP-family models using the 1171306 igniter. Confirm the igniter mount and connector before ordering.

Installation Guide

1. Safety First — Disconnect power at the furnace switch and breaker, then verify zero voltage with a multimeter. Handle the new igniter by its ceramic base only — never touch the element.
2. Access — Remove the burner compartment door.
3. Document — Photograph the igniter position and wiring routing before disconnecting.
4. Remove — Unplug the igniter connector and unscrew the old igniter from its bracket.
5. Install — Mount the new igniter (do not touch the element), connect the new wiring kit, and route the harness clear of hot surfaces.
6. Test — Restore power, start a heat cycle, and confirm the igniter glows and the burners light promptly.

Signs You Need a Replacement

• No heat / furnace locks out on failed ignition
• Igniter does not glow or glows weakly
• Visible cracks or pitting on the element
• Delayed ignition with a gas-smell or rumble

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.