ICP Hot Surface Igniter Sparker for RGS180SEEA0AAAA — Direct Spark Ignitor | Ships Today

Overview

This OEM spark ignitor (part number 1184216) is the ignition component for the ICP Tempstar Heil RGS180SEEA0AAAA gas furnace. The igniter generates the high-voltage spark that lights the burners on each call for heat. When an igniter fails or weakens, the furnace will fail to light, lock out after several ignition attempts, or short-cycle on startup. A clean, properly gapped igniter is essential for reliable, safe furnace operation.

Specifications

Compatibility

Designed as a direct OEM fit for the ICP Tempstar Heil RGS180SEEA0AAAA gas furnace and shared-platform RGS180 series units. Always confirm your model and serial number before ordering.

Installation Guide

1. Safety First — Disconnect power at the furnace switch and breaker, shut off the gas, and verify zero voltage with a multimeter.
2. Access — Remove the furnace front service panel.
3. Document — Photograph the igniter wiring and bracket position before disconnecting.
4. Remove — Disconnect the igniter lead, remove the mounting screw, and lift the old igniter from the burner assembly.
5. Install — Mount the new igniter, set the correct spark gap, and reconnect the lead per your photo.
6. Test — Restore gas and power, then verify clean ignition through a full heat cycle.

Signs You Need a Replacement

• Furnace fails to light or locks out after repeated ignition attempts
• Weak, intermittent, or no spark at the burners
• Cracked, eroded, or carbon-fouled igniter tip
• Short-cycling on startup with no heat output

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.