ICP Hot Surface Igniter Kit for WFHR060B036A1 — with Bracket | Ships Today

Overview

This is the OEM hot surface igniter (part number 1176919) for the ICP / Heil / Tempstar WFHR060B036A1 gas furnace, supplied with its mounting bracket (1177210) and matched to the furnace's slow-opening HSI gas valve (1177204, 36J24510). The igniter is a silicon nitride/carbide element that glows red-hot to light the burners on each heat cycle. Because it heats and cools every cycle, it is a high-wear part and one of the most common no-heat failures. Typical symptoms are a furnace that tries to start but never lights, an igniter that no longer glows, or repeated ignition lockouts.

Specifications

Compatibility

Direct OEM replacement for the WFHR060B036A1 furnace and other ICP-family Heil, Tempstar, and Comfortmaker units using igniter 1176919 with bracket 1177210. Match your existing igniter shape and terminal plug before ordering.

Installation Guide

1. Safety First — Disconnect power at the furnace switch and breaker, then verify zero voltage with a multimeter.
2. Access — Remove the furnace burner-compartment service panel.
3. Document — Photograph the igniter position, bracket, and wiring before disconnecting.
4. Remove — Unplug the igniter lead and remove the bracket screw; handle the old igniter by its ceramic base only, never the element.
5. Install — Mount the new igniter and bracket without touching the element, then reconnect the lead per your photos.
6. Test — Restore power, call for heat, and confirm the igniter glows and the burners light cleanly.

Signs You Need a Replacement

• Furnace attempts to start but burners never light.
• Igniter no longer glows or glows weakly.
• Cracked or broken igniter element.
• Repeated ignition lockouts after several retries.

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. National HVAC Parts fitment guarantee.