ICP Hot Surface Igniter Kit for WFAR080C060C1 — OEM 1176919 with Bracket | Ships Today

Overview

This genuine OEM hot surface igniter (part number 1176919) with its mounting bracket (part number 1184324) lights the burners on the ICP/Tempstar/Heil WFAR080C060C1 gas furnace. On each call for heat, the control board energizes the igniter, which glows to roughly 2,000°F and ignites the gas as it exits the burners. Hot surface igniters are brittle and degrade with every cycle — they are the single most common failure point on a modern gas furnace. A cracked or burned-out igniter produces a furnace that runs the inducer and blower but never lights, often with a flashing fault code.

Specifications

Compatibility

Built for the ICP WFAR080C060C1 furnace and shared across ICP-family models (Tempstar, Heil, Comfortmaker, Arcoaire) using this hot surface igniter and bracket assembly. The included bracket ensures correct positioning of the igniter element over the burner.

Installation Guide

1. Safety First — Disconnect power and shut off the gas, then verify zero voltage with a multimeter.
2. Access — Remove the burner compartment service panel.
3. Document — Photograph the igniter position and wiring connector.
4. Remove — Unscrew the old igniter bracket and unplug the connector. Handle only by the ceramic base — never touch the igniter element.
5. Install — Mount the new igniter and bracket, align the element over the burner, and reconnect the plug.
6. Test — Restore gas and power, then watch a full ignition cycle to confirm the burners light.

Signs You Need a Replacement

• Furnace runs the inducer but burners never light
• Visible cracks or breaks in the igniter element
• No glow during the ignition sequence
• Ignition fault code flashing on the control board

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.