ICP Hot Surface Igniter Kit for RGS150HFAA0AKAA — With Wiring Harness | Ships Today

Overview

This OEM hot surface igniter kit for the ICP/Heil/Tempstar RGS150HFAA0AKAA includes the igniter element (P/N 1171306) and the matching igniter wiring kit (P/N 1188370). On a call for heat, the control board energizes the igniter, which glows red-hot to ignite the gas at the burners. Hot surface igniters are brittle and degrade with every heat cycle, eventually cracking or losing the ability to reach ignition temperature. The included wiring kit ensures a clean, correct electrical connection and replaces brittle or heat-damaged leads. A failed igniter is one of the most common no-heat causes — installing the OEM igniter with fresh wiring restores fast, dependable ignition.

Specifications

Compatibility

Designed for the ICP/Heil/Tempstar RGS150HFAA0AKAA and related gas furnaces using a hot surface ignition system. Confirm your igniter mounting style before ordering.

Installation Guide

1. Safety First — Shut off gas and disconnect power; verify zero voltage with a multimeter.
2. Access — Remove the burner compartment panel.
3. Document — Photograph the igniter position and wiring routing before disconnecting.
4. Remove — Unplug the igniter harness and unscrew the old igniter; handle the new element by its base only — never touch the silicon carbide tip.
5. Install — Mount the new igniter, connect the new wiring kit, and route leads clear of hot surfaces.
6. Test — Restore gas and power, then run a heat cycle and confirm the igniter glows and burners light.

Signs You Need a Replacement

• No heat — igniter fails to glow on a call for heat
• Visible cracks or breaks in the igniter element
• Furnace locks out after failed ignition attempts
• Brittle, frayed, or heat-damaged igniter wiring

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.