ICP Hot Surface Igniter Kit for RGS150HDAA0AGAA — OEM 1171306 | Ships Today

Overview

Genuine OEM hot surface igniter (part 1171306) with available wiring kit (part 1188370) for the ICP / Tempstar / Heil RGS150HDAA0AGAA gas furnace. The hot surface igniter glows red-hot when energized to light the burners on each heat call. Igniters are a normal wear item — the silicon-carbide or nitride element becomes brittle and eventually cracks from repeated thermal cycling. A failed igniter is the most common reason a furnace blows cold air or locks out without lighting. The matching wiring kit ensures clean, corrosion-free connections during the swap.

Specifications

Compatibility

Designed for the ICP-built RGS150HDAA0AGAA furnace and shared Tempstar, Heil, and Comfortmaker gas furnaces using the same ignition system. Confirm the OEM igniter number 1171306 and your model before ordering; add the 1188370 wiring kit if your harness or plug shows heat damage.

Installation Guide

1. Safety First — Shut off gas and disconnect power at the furnace switch and breaker; verify zero voltage with a multimeter.
2. Access — Remove the burner compartment service panel.
3. Document — Photograph the igniter mounting position and wire routing before disconnecting.
4. Remove — Unplug the igniter harness, remove the mounting screw, and lift out the old igniter — handle the new element by its base only, never the fragile tip.
5. Install — Seat the new igniter at the correct depth/angle, secure the screw, and connect using the new wiring kit if included.
6. Test — Restore gas and power, call for heat, and confirm the igniter glows and the burners light promptly.

Signs You Need a Replacement

• Furnace blows cold air and never lights
• Igniter shows visible cracks or no longer glows
• Control board locks out after several failed ignition attempts
• Delayed ignition or a rough/loud light-off

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.