ICP Hot Surface Igniter Kit for RGS102LTCB0AAA — OEM 1171306 | Ships Today

Overview

This OEM hot surface igniter (part number 1171306) ships with the matching igniter wiring kit (part number 1188370) for the ICP / Tempstar / Heil RGS102LTCB0AAA gas furnace. The igniter is the component the control board energizes at the start of each heat cycle — it glows white-hot to light the burners. Hot surface igniters are brittle and wear out with every cycle; they crack, develop hairline fractures, or simply fail to reach ignition temperature, leaving you with a furnace that clicks and clicks but never lights. The included wiring kit ensures a clean, factory-correct electrical connection.

Specifications

Compatibility

Designed for the ICP-family RGS102LTCB0AAA and the Tempstar, Heil, and Comfortmaker variants using this igniter and harness. Confirm OEM numbers 1171306 and 1188370 against your furnace before ordering.

Installation Guide

1. Safety First — Disconnect power to the furnace and shut off the gas. Verify zero voltage with a multimeter. Handle the igniter only by its ceramic base — never touch the silicon nitride element.
2. Access — Remove the burner compartment service panel.
3. Document — Photograph the igniter mounting and wire routing before removal.
4. Remove — Unplug the igniter harness, remove the mounting screw, and lift the old igniter clear without bumping the element.
5. Install — Seat the new igniter in the same position, install the wiring kit, and reconnect the harness per your photos.
6. Test — Restore gas and power, start a heat call, and confirm the igniter glows and lights the burners on the first cycle.

Signs You Need a Replacement

• Furnace clicks but burners never ignite
• Visible cracks or breaks in the igniter element
• Igniter glows weakly or not at all during the call for heat
• Repeated ignition lockouts after several failed attempts

Shipping & Returns

Ships same day on orders placed before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.