ICP Hot Surface Igniter Kit for RGS102LDCB0AAA — OEM 1171306 | Ships Today

Overview

This genuine OEM hot surface igniter (part 1171306) — bundled with the matching igniter wiring kit (1188370) — provides reliable ignition for the ICP / Tempstar / Heil RGS102LDCB0AAA gas furnace. On a heat call, the control board energizes the igniter, which glows to a high temperature and lights the burners. Hot surface igniters are brittle and degrade over many heating cycles; a cracked or worn element is one of the most common causes of furnace no-heat calls. The included wiring kit ensures a clean electrical connection during replacement.

Specifications

Compatibility

Designed for the ICP-family RGS102LDCB0AAA furnace and the shared Tempstar/Heil/Comfortmaker furnace platforms using this igniter and burner assembly. Match part 1171306 to your existing igniter before ordering.

Installation Guide

1. Safety First — Disconnect power to the furnace; verify zero voltage with a multimeter.
2. Access — Remove the burner compartment service panel.
3. Document — Photograph the igniter mounting position and wire routing before disconnecting.
4. Remove — Unplug the igniter connector, remove the mounting screw(s), and carefully withdraw the old igniter — handle by the base only, never the element.
5. Install — Mount the new igniter (do not touch the element with bare fingers), and connect using the supplied wiring kit per your photo.
6. Test — Restore power, start a heat cycle, and confirm the igniter glows and the burners light promptly.

Signs You Need a Replacement

• Furnace clicks/calls for heat but burners never light
• Igniter element is cracked, broken, or no longer glows
• Intermittent ignition or repeated lockouts
• Visible hot spots, blistering, or carbon on the element

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.