ICP Hot Surface Igniter Kit for RGS102HSBB0AAA — 120V with Wiring Harness | Ships Today

Overview

This OEM hot surface igniter kit pairs the igniter (part #1171306) with the matching igniter wiring kit (part #1188370) for the ICP/Heil/Tempstar RGS102HSBB0AAA gas furnace. On a call for heat the control board sends 120V to the igniter, which glows red-hot to ignite the gas at the burners. Hot surface igniters are brittle silicon-carbide or silicon-nitride elements that degrade with every heating cycle and eventually crack or lose conductivity. Typical failure symptoms include no ignition, the furnace locking out after several failed trial-for-ignition cycles, a glowing igniter that never lights the burners, or a visibly cracked element.

Specifications

Compatibility

Designed as the factory replacement for the ICP/Heil/Tempstar RGS102HSBB0AAA and compatible furnaces in the ICP family that use this hot surface igniter and harness. The included wiring kit ensures a clean plug-and-play connection to the furnace control board.

Installation Guide

1. Safety First — Shut off gas and disconnect 120V power at the furnace switch; verify zero voltage with a multimeter.
2. Access — Remove the burner compartment door.
3. Document — Photograph the igniter bracket and harness routing before removal.
4. Remove — Unplug the igniter harness, remove the mounting screw, and lift out the old igniter without touching the element.
5. Install — Mount the new igniter (handle by the ceramic base only), route and connect the new wiring kit per your photo.
6. Test — Restore gas and power, initiate a heat call, and confirm the igniter glows and lights the burners on the first trial.

Signs You Need a Replacement

• Furnace will not ignite or locks out after repeated attempts
• Igniter glows but burners never light
• Visible cracks, chips, or white spots on the element
• No glow at all during a call for heat

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.